Standard Icemaker Water Overfilling Tray

Standard Icemaker Water Overfilling Tray 1) If water is overfilling the icemaker tray the first check should be water pressure. Make sure that the water pressure is not too high or too low, either case could cause the tray to overfill. Normal water pressure range is (20-120PSI). 2) Make sure all cubes are ejecting from […]

Icemaker Test Mode Symptoms

Icemaker Test Mode Symptoms This article will discuss the failures you might experience while trying to run test mode on an icemaker and the tests that should follow to troubleshoot each issue. If you need information on how to run test mode on your specific icemaker, click the button below for your icemaker type: Standard […]

Craft Icemaker SW Update

Craft ICEMAKER Software Update Many Craft Icemaker replacements require a Software Update to be performed. If you are unsure if your model requires a software update, look for service bulletins listed for your specific model. To do this you will need to use GSFS or LGTA App. The Service bulletins are: CNZ202200380-01, CNZ202200379-01, CNZ202200378-01 Special […]

How to Replace Craft Icemaker Side By Side

How to Replace Craft Icemaker (Side-by-Side) https://lgrepaircenter.com/wp-content/uploads/2023/06/REF-Ice-Maker-Replacement-Craft-23-048_10_1.mp4 *Note: Some Craft Icemakers require a Software Update be performed to the Main PCB. Be sure to check the Service Bulletins for your specific model to see if a Software Update is necessary. 

How to Replace Craft Icemaker French Door

How to Replace Craft or Standard Icemaker (French Door Freezer Section) https://lgrepaircenter.com/wp-content/uploads/2023/06/REF-Ice-Maker-Replacement-Bottom-Freezer-23-051_2_1.mp4 *Note: Some Craft Icemakers require a Software Update be performed to the Main PCB. Be sure to check the Service Bulletins for your specific model to see if a Software Update is necessary.