If the power cord is damaged, stop using the product immediately and unplug it from the outlet. Do not use the product again until the power cord has been replaced. Be sure to wear gloves and any other required PPE for your safety. We will now review the repair steps.

Note;

Do Not begin repairs until the power cord is unplugged from the outlet.

1.  Confirm the unit is unplugged, then access the rear control panel (example shown is a WT8**). Remove the screws, then remove the rear control panel cover by unsnapping its clips.

2. After removing the rear panel, you will notice that the water valve assembly covers the power cord within its molded strain relief. The water valve assembly will need to be removed. It is secured by two clips, one on each end of the assembly. Release the clips, then pull the assembly toward you and upward to remove it.

3. Once the water valve assembly is removed locate the Filter Assembly and remove it by removing one screw and lifting.

4. Remove the ground wire.

5. Disconnect the power cord assembly from the Filter Board.

6. Replace the Power Cord by reversing the process.